Brocade Communications Systems FastIron X Series User Manual

5. Enter the set local-preference command and specify a value to set a BGP local-preference path attribute.
device(config-route-map-ComRmap)# set local-preference 200
6. Enter the router bgp command to enable BGP routing.
device(config)# router bgp
7. Enter the local-as command to congure the autonomous system number (ASN) in which your device resides.
device(config-bgp-router)# local-as 1000
8. Enter the neighbor ipv6-address remote-as command to specify the ASN in which the remote neighbor resides.
device(config-bgp-router)# neighbor fe80:4398:ab30:45de::1 remote-as 1001
9. Enter the neighbor ipv6-address update-source command to specify an interface.
device(config-bgp-router)# neighbor fe80:4398:ab30:45de::1 update-source ve 1000
10. Enter the address-family command and specify the ipv6 and unicast keywords to enter IPv6 address family
conguration
mode.
device(config-bgp-router)# address-family ipv6 unicast
11. Enter the neighbor ipv6-address activate command to enable the exchange of information with the neighbor.
device(config-bgp-ipv6u)# neighbor fe80:4398:ab30:45de::1 activate
12. Enter the neighbor ipv6-address route-map command and specify the in keyword to apply a route map to incoming routes.
device(config-bgp-ipv6u)# neighbor fe80:4398:ab30:45de::1 route-map in ComRmap
13. Enter the neighbor ipv6-address send-community command to enable the sending of standard and extended attributes in
updates to the
specied BGP neighbor.
device(config-bgp-ipv6u)# neighbor fe80:4398:ab30:45de::1 send-community
The following example applies a BGP extended community lter.
device# configure terminal
device(config)# ip community-list extended 1 permit ^[1-2]23
device(config)# route-map ComRmap permit 10
device(config-route-map-ComRmap)# match community 1
device(config-route-map-ComRmap)# set local-preference 200
device(config)# router bgp
device(config-bgp-router)# local-as 1000
device(config-bgp-router)# neighbor fe80:4398:ab30:45de::1 remote-as 1001
device(config-bgp-router)# neighbor fe80:4398:ab30:45de::1 update-source ve 1000
device(config-bgp-router)# address-family ipv6 unicast
device(config-bgp-ipv6u)# neighbor fe80:4398:ab30:45de::1 activate
device(config-bgp-ipv6u)# neighbor fe80:4398:ab30:45de::1 route-map in ComRmap
device(config-bgp-ipv6u)# neighbor fe80:4398:ab30:45de::1 send-community
Disabling BGP4+ graceful restart
The BGP4+ graceful restart (GR) feature is enabled by default, and can be disabled on a routing device.
1. Enter the
congure terminal command to access global conguration mode.
device# configure terminal
Conguring BGP4+
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04 497

Brocade Communications Systems FastIron X Series Specifications

General

Brand	Brocade Communications Systems
Model	FastIron X Series
Category	Switch
Language	English