Brocade Communications Systems FastIron X Series User Manual

TABLE 58 show ip ospf neighbor output descriptions (continued)
Field Description
Cnt The number of LSAs that were retransmitted.
Displaying OSPF interface information
To display OSPF interface information, enter the following command at any CLI level. The details of interface options are highlighted in
the output.
device# show ip ospf interface ethernet 1/1/11
Ethernet 1/1/11 admin up, oper up
IP Address 15.1.1.15, Area 0
Database Filter: Not Configured
State active(default passive), Pri 1, Cost 1, Options 2,Type broadcast Events 2
Timers(sec): Transmit 1, Retrans 5, Hello 10, Dead 40
DR: Router ID 192.168.254.1 Interface Address 15.1.1.1
BDR: Router ID 10.0.0.15 Interface Address 15.1.1.15
Neighbor Count = 1, Adjacent Neighbor Count= 1
Neighbor: 15.1.1.1 (DR)
Authentication-Key: None
MD5 Authentication: Key None, Key-Id None, Auth-change-wait-time 300
If you specify an interface that is not
congured within a specied VRF, then the following error message will display as shown in the
example below:
device# show ip ospf vrf one interface ethernet 1/1/1
Error: Interface(eth 1/1/1) not part of VRF(one)
NOTE
You cannot display multiple ports for any interfaces. For example, when displaying OSPF interface information on ethernet
1/1/1 only one port can displayed at a given time.
Syntax: show ip ospf [ vrf vrf-name ] interface [ ip-addr ] [ brief ] [ ethernet unit/slot/port | loopback number | tunnel number | ve
number ]
The vrf vrf-name parameter displays information for VRF, or a specic vrf-name.
The ip-addr parameter displays the OSPF interface information for the specied IP address.
The brief parameter displays interface information in the brief mode.
The ethernet, loopback, tunnel, and ve parameters to specify the interface for which to display information. If you specify an Ethernet
interface, you can also specify the unit, slot and port number associated with the interface. If you specify a loopback, tunnel, or VE
interface, you can also specify the number associated with the interface.
TABLE 59 show ip ospf interface output descriptions
This eld Displays
Interface The type of interface type and the port number or number of the interface.
IP Address The IP address of the interface.
Area The OSPF area congured on the interface
Database Filter The router’s conguration for blocking outbound LSAs on an OSPF
interface.
If Not Congured is displayed, there is no outbound LSA lter congured.
This is the default condition.
Displaying OSPF information
FastIron Ethernet Switch Layer 3 Routing
276 53-1003627-04

Brocade Communications Systems FastIron X Series Specifications

General

Brand	Brocade Communications Systems
Model	FastIron X Series
Category	Switch
Language	English