• Hold-down timer: 9 through 65535 seconds.
• Garbage-collection timer: 9 through 65535 seconds.
NOTE
You must enter a value for each timer, even if you want to retain the current setting of a particular timer.
To return to the default values of the RIPng timers, use the no form of this command.
Conguring route learning and advertising parameters
You can
congure the following learning and advertising parameters:
• Learning and advertising of RIPng default routes.
• Advertising of IPv6 address summaries.
• Metric of routes learned and advertised on a Brocade device interface.
Conguring default route learning and advertising
By default, the device does not learn IPv6 default routes (::/0). You can originate default routes into RIPng, which causes individual
Brocade device interfaces to include the default routes in their updates. When conguring the origination of the default routes, you can
also do the following:
• Suppress all other routes from the updates.
• Include all other routes in the updates.
For example, to originate default routes in RIPng and suppress all other routes in updates sent from Ethernet interface 1/3/1, enter the
following commands.
device(config)# interface ethernet 1/3/1
device(config-if-e100-1/3/1)# ipv6 rip default-information only
To originate IPv6 default routes and include all other routes in updates sent from Ethernet interface 1/3/1, enter the following
commands.
device(config)# interface ethernet 1/3/1
device(config-if-e100-1/3/1)# ipv6 rip default-information originate
Syntax: [no] ipv6 rip default-information { only | originate }
The only keyword originates the default routes and suppresses all other routes from the updates.
The originate keyword originates the default routes and includes all other routes in the updates.
To remove the explicit default routes from RIPng and suppress advertisement of these routes, use the no form of this command.
Advertising IPv6 address summaries
You can
congure RIPng to advertise a summary of IPv6 addresses from a Brocade device interface and to specify an IPv6 prex that
summarizes the routes.
If a route’s prex length matches the value specied in the ipv6 rip summary-address command, RIPng advertises the prex specied in
the ipv6 rip summary-address command instead of the original route.
Conguring RIPng
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04 217
To Next Page
Loading...
Need help?
General
