TABLE 56 show ip ospf cong output descriptions (continued)
Field Description
OSPF Redistribution Metric Shows the OSPF redistribution metric type, which can be one of the
following:
• Type1
• Type2
OSPF External LSA Limit Shows the external LSA limit value.
OSPF Database Overow Interval Shows the database overow interval value.
RFC 1583 Compatibility Shows whether or not the RFC 1583 compatibility is enabled.
Router id Shows the ID of the OSPF router.
OSPF traps Shows whether or not the following OSPF traps generation is enabled.
• Interface State Change Trap
• Virtual Interface State Change Trap
• Neighbor State Change Trap
• Virtual Neighbor State Change Trap
• Interface Conguration Error Trap
• Virtual Interface Conguration Error Trap
• Interface Authentication Failure Trap
• Virtual Interface Authentication Failure Trap
• Interface Receive Bad Packet Trap
• Virtual Interface Receive Bad Packet Trap
• Interface Retransmit Packet Trap
• Virtual Interface Retransmit Packet Trap
• Originate LSA Trap
• Originate MaxAge LSA Trap
• Link State Database Overow Trap
• Link State Database Approaching Overow Trap
Area-ID Shows the area ID of the interface.
Area-Type Shows the area type, which can be one of the following:
• nssa
• normal
• stub
Cost Shows the cost of the area.
Ethernet Interface Shows the OSPF interface.
ip ospf md5-authentication-key-activation-wait-time Shows the wait time of the device until placing a new MD5 key into eect.
ip ospf area Shows the area of the interface.
ip ospf cost Shows the overhead required to send a packet across an interface.
Displaying OSPF area information
To display OSPF area information, enter the following command at any CLI level.
device# show ip ospf area
Indx Area Type Cost SPFR ABR ASBR LSA Chksum(Hex)
1 0.0.0.0 normal 0 1 0 0 1 0000781f
2 10.147.60.0 normal 0 1 0 0 1 0000fee6
3 10.147.80.0 stub 1 1 0 0 2 000181cd
Syntax: show ip ospf area [ area-id ] [ num ]
Displaying OSPF information
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04 273