Brocade Communications Systems FastIron X Series User Manual

4. Enter the neighbor peer-group-name peer-group command to create a peer group.
device(config-bgp-router)# neighbor mypeergroup1 peer-group
5. Enter the neighbor peer-group-name remote-as command to specify the ASN of the peer group.
device(config-bgp-router)# neighbor mypeergroup1 remote-as 11
6. Enter the neighbor ipv6-address peer-group command to associate a neighbor with the peer group.
device(config-bgp-router)# neighbor 2001:2018:8192::125 peer-group mypeergroup1
7. Enter the neighbor ipv6-address peer-group command to associate a neighbor with the peer group.
device(config-bgp-router)# neighbor 2001:2018:8192::124 peer-group mypeergroup1
8. Enter the address-family command and specify the ipv6 and unicast keywords to enter IPv6 address family
conguration
mode.
device(config-bgp-router)# address-family ipv6 unicast
9. Enter the neighbor peer-group-name activate command to establish an IPv6 BGP session with the peer group.
device(config-bgp-ipv6u)# neighbor mypeergroup1 activate
The following example creates a peer group, specifying two neighbors to belong to the peer group, and activates the peer group.
device# configure terminal
device(config)# router bgp
device(config-bgp-router)# local-as 1000
device(config-bgp-router)# neighbor mypeergroup1 peer-group
device(config-bgp-router)# neighbor mypeergroup1 remote-as 11
device(config-bgp-router)# neighbor 2001:2018:8192::125 peer-group mypeergroup1
device(config-bgp-router)# neighbor 2001:2018:8192::124 peer-group mypeergroup1
device(config-bgp-router)# address-family ipv6 unicast
device(config-bgp-ipv6u)# neighbor mypeergroup1 activate
Conguring a peer group with IPv4 and IPv6 peers
A peer group that contains both IPv4 and IPv6 peers can be
congured.
1. Enter the congure terminal command to access global conguration mode.
device# configure terminal
2. Enter the router bgp command to enable BGP routing.
device(config)# router bgp
3. Enter the local-as command to congure the autonomous system number (ASN) in which your device resides.
device(config-bgp-router)# local-as 1000
4. Enter the neighbor peer-group-name peer-group command to create a peer group.
device(config-bgp-router)# neighbor p1 peer-group
5. Enter the neighbor peer-group-name remote-as command to specify the ASN of the peer group.
device(config-bgp-router)# neighbor p1 remote-as 11
Conguring BGP4+
FastIron Ethernet Switch Layer 3 Routing
486 53-1003627-04

Brocade Communications Systems FastIron X Series Specifications

General

Brand	Brocade Communications Systems
Model	FastIron X Series
Category	Switch
Language	English