Displaying OSPF Router Advertisement
Using the show ip ospf command you can display the current OSPF Router Advertisement conguration.
device# show ip ospf
OSPF Version Version 2
Router Id 192.168.98.213
ASBR Status Yes
ABR Status Yes (1)
Redistribute Ext Routes from Connected RIP
Initial SPF schedule delay 0 (msecs)
Minimum hold time for SPFs 0 (msecs)
Maximum hold time for SPFs 0 (msecs)
External LSA Counter 2
External LSA Checksum Sum 000104fc
Originate New LSA Counter 737
Rx New LSA Counter 1591
External LSA Limit 6990506
Database Overflow Interval 0
Database Overflow State : NOT OVERFLOWED
RFC 1583 Compatibility : Enabled
NSSA Translator: Enabled
Nonstop Routing: Disabled
Graceful Restart: Enabled, timer 120
Graceful Restart Helper: Enabled O 35m5s
Displaying OSPF information
You can use CLI commands and Web management options to display the following OSPF information:
• Trap, area, and interface information
• CPU utilization statistics
• Area information
• Neighbor information
• Interface information
• Route information
• External link state information
• Database Information
• Link state information
• Virtual Neighbor information
• Virtual Link information
• ABR and ASBR information
• Trap state information
• OSPF Point-to-Point Links
• OSPF Graceful Restart information
• OSPF Router Advertisement information
Displaying general OSPF conguration information
To display general OSPF conguration information, enter the following command at any CLI level.
device# show ip ospf config
Router OSPF: Enabled
Displaying OSPF information
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04 271
To Next Page
Loading...
Need help?
General
