IPv6 CLI command support
IPv6 CLI command support lists the IPv6 CLI commands supported.
TABLE 30 IPv6 CLI command support
IPv6 command Description Switch code Router code
clear ipv6 cache Deletes all entries in the dynamic
host cache.
X
clear ipv6 mld-snooping Deletes MLD-snooping-related
counters or cache entries.
X X
clear ipv6 neighbor Deletes all dynamic entries in the
IPv6 neighbor table.
X X
clear ipv6 ospf Clears OSPF-related entries. X
clear ipv6 rip Clears RIP-related entries. X
clear ipv6 route Deletes all dynamic entries in the
IPv6 route table.
X
clear ipv6 trac Resets all IPv6 packet counters. X X
clear ipv6 tunnel Clears statistics for IPv6 tunnels X
copy tftp Downloads a copy of a Brocade
software image from a TFTP server
into the system ash using IPv6.
X X
debug ipv6 Displays IPv6 debug information. X X
ipv6 access-class Congures access control for IPv6
management trac.
X X
ipv6 access-list Congures an IPv6 access control
list for IPv6 access control.
X X
ipv6 address Congures an IPv6 address on an
interface (router) or globally (switch)
X X
ipv6 debug Enables IPv6 debugging. X X
ipv6 dns domain-name Congures an IPv6 domain name. X X
ipv6 dns server-address Congures an IPv6 DNS server
address.
X X
ipv6 enable Enables IPv6 on an interface. X X
ipv6 hop-limit Sets the IPv6 hop limit. X
ipv6 icmp Congures IPv6 ICMP parameters X
Ipv6 load-sharing Enables IPv6 load sharing X
Ipv6 mld-snooping Congures MLD snooping X X
ipv6 mtu Congures the maximum length of
an IPv6 packet that can be
transmitted on a particular interface.
X
ipv6 nd Congures neighbor discovery. X
ipv6 neighbor Maps a static IPv6 address to a
MAC address in the IPv6 neighbor
table.
X
ipv6 ospf Congures OSPF V3 parameters
on an interface.
X
ipv6 prex-list Builds an IPv6 prex list. X
ipv6 redirects Enables the sending of ICMP
redirect messages on an interface.
X
IPv6 CLI command support
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04 155
To Next Page
Loading...
Need help?
General
