Brocade Communications Systems FastIron X Series User Manual

TABLE 92 IPv4 BGP4 commands for dierent conguration levels (continued)
Command Global (iPv4 and IPv6) IPv4 address family unicast
log-dampening-debug x
maxas-limit x
maximum-paths x
med-missing-as-worst x
multipath x
neighbor x x
network x
next-hop-enable-default x
next-hop-recursion x
redistribute x
rib-route-limit x
show x x
static-network
table-map x
timers x
update-time x
Entering and exiting the address family conguration
level
The BGP4 address family contains a unicast sub-level.
To go to the IPv4 BGP4 unicast address family
conguration level, enter the following command.
device(config-bgp)# address-family ipv4 unicast
device(config-bgp)#
NOTE
The CLI prompt for the global BGP4 level and the BGP4 address-family IPv4 unicast level is the same.
Syntax: [no] address-family ipv4 unicast [ vrf vrf-name ]
The default is the IPv4 unicast address family level.
The vrf option allows you to congure a unicast instance for the VRF specied by the vrf-name variable.
To exit an address family conguration level, enter the following command.
device(config-bgp)# exit-address-family
device(config-bgp)#
Syntax: [no] exit-address-family
Entering and exiting the address family conguration level
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04 429

Brocade Communications Systems FastIron X Series Specifications

General

Brand	Brocade Communications Systems
Model	FastIron X Series
Category	Switch
Language	English