Brocade Communications Systems FastIron X Series User Manual

If you specify an Ethernet interface, also specify the unit / slot / port number associated with the interface. If you specify a VE interface,
also specify the VE number. If you specify a tunnel interface, also specify the tunnel number.
This display shows the following information.
TABLE 32 IPv6 cache information elds
Field Description
Total number of cache entries The number of entries in the cache table.
IPv6 Address The host IPv6 address.
Next Hop The next hop, which can be one of the following:
• Direct - The next hop is directly connected to the router.
• Local - The next hop is originated on this router.
• ipv6 address - The IPv6 address of the next hop.
Port The port on which the entry was learned.
Displaying IPv6 interface information
To display IPv6 interface information, enter the following command at any CLI level.
device#show ipv6 interface
Routing Protocols : R - RIP O - OSPF
Interface Status Routing Global Unicast Address
Ethernet 1/3/3 down/down R
Ethernet 1/3/5 down/down
Ethernet 1/3/17 up/up 2017::c017:101/64
Ethernet 1/3/19 up/up 2019::c019:101/64
VE 4 down/down
VE 14 up/up 2024::c060:101/64
Loopback 1 up/up ::1/128
Loopback 2 up/up 2005::303:303/128
Loopback 3 up/up
Syntax: show ipv6 interface [ interface [ unit / slot / port | number ] ]
The interface parameter displays detailed information for a
specied interface. For the interface, you can specify the Ethernet , loopback ,
tunnel , or VE keywords. If you specify an Ethernet interface, also specify unit / slot / port . If you specify a loopback, tunnel, or VE
interface, also specify the number associated with the interface.
This display shows the following information.
TABLE 33 General IPv6 interface information
elds
Field Description
Routing protocols A one-letter code that represents a routing protocol that can be enabled
on an interface.
Interface The interface type, and the port number or number of the interface.
Status The status of the interface. The entry in the Status eld will be either
"up/up" or "down/down".
Routing The routing protocols enabled on the interface.
Global Unicast Address The global unicast address of the interface.
To display detailed information for a specic interface, enter a command such as the following at any CLI level.
device#show ipv6 interface ethernet 1/3/1
Interface Ethernet 1/3/1 is up, line protocol is up
IPv6 is enabled, link-local address is fe80::2e0:52ff:fe99:97
Displaying global IPv6 information
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04 181

Brocade Communications Systems FastIron X Series Specifications

General

Brand	Brocade Communications Systems
Model	FastIron X Series
Category	Switch
Language	English