TABLE 73 show ipv6 interface output descriptions
Field Description
Type Codes Shows the routing protocol enabled on the interface. The routing protocol
can be one of the following:
• R - RIP
• O - OSPF
Interface Shows the type, unit, slot, and port number of the interface.
Stat/Port Shows the status of the link and the protocol for the interface. The status
can be one of the following:
• Up
• Down
IGPs Shows the type of the Interior Gateway Protocols (IGPs) enabled on the
interface.
IPv6 Address Shows the link local IPv6 address congured for the interface.
VRF Species the VRF to which the interface belongs.
Displaying IPv6 OSPFv3 interface information
IPv6 Interface information can be displayed in either a brief or full mode. The following sections describe the command to display these
modes and the resulting output:
• Displaying IPv6 OSPFv3 Interface Information in Brief Mode
• Displaying IPv6 OSPFv3 Interface Information in Full Mode
Displaying IPv6 OSPFv3 interface information in brief mode
You can use the following command to display a summary of IPv6 Interface information.
device# show ipv6 ospf interface brief
Interface Area Status Type Cost State Nbrs (F/C)
eth 1/1/1 0 up BCST 1 DROther 1/1
loopback 1 0 up BCST 1 Loopback 0/0
Syntax: show ipv6 ospf interface brief
TABLE 74 show ipv6 ospf interface brief output descriptions
This eld Displays
Number of Interfaces Number of OSPFv3-enabled interfaces.
Interface The interface type, and the unit, slot, and port number or number of the
interface.
Area The OSPF area congured on the interface.
Status The status of the link and the protocol. Possible status include the
following:
• Up.
• Down.
Type The type of OSPFv3 circuit running on the interface. Possible types
include the following:
• BCST- Broadcast interface type
• P2P- Point-to-point interface type
• UNK- The interface type is not known at this time
Displaying OSPFv3 information
FastIron Ethernet Switch Layer 3 Routing
326 53-1003627-04