EasyManuals Logo

Brocade Communications Systems FastIron X Series User Manual

Brocade Communications Systems FastIron X Series
593 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #519 background imageLoading...
Page #519 background image
Enabling an owner VRRP device
This task is performed on the device that is designated as the owner VRRP device because the IP address of one of its physical
interfaces is assigned as the IP address of the virtual router. For example, Router 1 is the owner VRRP device In the diagram below. For
each VRRP session there are master and backup routers, the owner router is elected, by default, as the master router.
FIGURE 36 Basic VRRP topology
1. On the device designated as the owner VRRP device, from privileged EXEC mode, enter conguration mode by issuing the
congure terminal command.
device# configure terminal
2. Globally enable the VRRP protocol.
device(config)# router vrrp
3. Congure the ethernet interface link for Router 1.
device(config)# interface ethernet 1/1/6
4. Congure the IP address of the interface.
device(config-if-e1000-1/1/6)# ip address 10.53.5.1/24
Basic VRRP parameter conguration
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04 519

Table of Contents

Other manuals for Brocade Communications Systems FastIron X Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brocade Communications Systems FastIron X Series and is the answer not in the manual?

Brocade Communications Systems FastIron X Series Specifications

General IconGeneral
BrandBrocade Communications Systems
ModelFastIron X Series
CategorySwitch
LanguageEnglish

Related product manuals