EasyManuals Logo

Brocade Communications Systems FastIron X Series User Manual

Brocade Communications Systems FastIron X Series
593 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #377 background imageLoading...
Page #377 background image
The software also contains an option to end the session with a BGP4 neighbor and clear the routes learned from the neighbor. Unlike
this clear option, the option for shutting down the neighbor can be saved in the startup conguration le and can prevent the device from
establishing a BGP4 session with the neighbor even after reloading the software.
NOTE
If you notice that a particular BGP4 neighbor never establishes a session with the device, check the running conguration and
startup conguration les for that device to see whether the conguration contains a command that is shutting down the
neighbor. The neighbor may have been shut down previously by an administrator.
To shut down a BGP4 neighbor, enter commands such as the following.
device(config)# router bgp
device(config-bgp-router)# neighbor 10.157.22.26 shutdown
device(config-bgp-router)# write memory
Syntax: [no] neighbor ip-addr shutdown [ generate-rib-out ]
The ip-addr parameter
species the IP address of the neighbor.
Optional BGP4 conguration tasks
The following sections describe how to perform optional BGP4 conguration tasks.
Changing the Keep Alive Time and Hold Time
The Keep Alive Time
species how frequently the device will send KEEPALIVE messages to its BGP4 neighbors. The Hold Time
species how long the device will wait for a KEEPALIVE or UPDATE message from a neighbor before concluding that the neighbor is
dead. When the device concludes that a BGP4 neighbor is dead, the device ends the BGP4 session and closes the TCP connection to
the neighbor.
The default Keep Alive time is 60 seconds. The default Hold Time is 180 seconds.
NOTE
Generally, you should set the Hold Time to three times the value of the Keep Alive Time.
NOTE
You can override the global Keep Alive Time and Hold Time on individual neighbors.
To change the Keep Alive Time to 30 and Hold Time to 90, enter the following command.
device(config-bgp-router)# timers keep-alive 30 hold-time 90
Syntax: [no] timers keep-alive num hold-time num
For each keyword, num indicates the number of seconds. The Keep Alive Time can be 0 - 65535. The Hold Time can be 0 or 3 -
65535 (1 and 2 are not allowed). If you set the Hold Time to 0, the device waits indenitely for messages from a neighbor without
concluding that the neighbor is dead.
Changing the BGP4 next-hop update timer
By default, the device updates the BGP4 next-hop tables and
aected BGP4 routes ve seconds after IGP route changes. You can
change the update timer to a value from 1 through 30 seconds.
Optional BGP4 conguration tasks
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04 377

Table of Contents

Other manuals for Brocade Communications Systems FastIron X Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brocade Communications Systems FastIron X Series and is the answer not in the manual?

Brocade Communications Systems FastIron X Series Specifications

General IconGeneral
BrandBrocade Communications Systems
ModelFastIron X Series
CategorySwitch
LanguageEnglish

Related product manuals