Brocade Communications Systems FastIron X Series User Manual

Device 1 and 2
The show ip route output for device 1 and device 2 shows "drop" under the Port column for the network prexes you congured with
null0 routing
device# show ip route
Total number of IP routes: 133
Type Codes - B:BGP D:Connected S:Static R:RIP O:OSPF; Cost - Dist/Metric
Destination Gateway Port Cost Type
1 10.0.1.24/32 DIRECT loopback 1 0/0 D
2 10.0.1.0/24 DIRECT eth 1/2/7 0/0 D
3 10.0.1.1/24 DIRECT eth 1/2/1 0/0 D
.
13 10.0.0.6/31 10.0.1.3 eth 1/2/2 20/1 B
14 10.0.0.16/30 10.0.1.3 eth 1/2/2 20/1 B
15 10.0.0.40/29 DIRECT drop
200/0 B
. .. . . . .
42 10.0.0.192/27 DIRECT drop
200/0 B
43 10.0.1.128/26 10.0.1.3 eth 1/2/7 20/1 B
. .. . . . .
69 10.0.7.0/24 10.0.1.3 eth 1/2/10 20/1 B
70 10.0.14.0/23 DIRECT drop 200/0 B
. .. . . . .
. .. . . . .
131 10.144.0.0/12 10.0.1.3 eth 1/3/4 20/1 B
132 10.199.1.1/32 DIRECT drop
1/1
Modifying redistribution parameters
By default, the route information between BGP4 and the IP IGPs (RIP and OSPF) is not redistributed. You can
congure the device to
redistribute OSPF routes, RIP routes, directly connected routes, or static routes into BGP4.
To enable redistribution of all OSPF routes and directly attached routes into BGP4, enter the following commands.
device(config)# router bgp
device(config-bgp-router)# redistribute ospf
device(config-bgp-router)# redistribute connected
device(config-bgp-router)# write memory
Syntax: [no] redistribute connected | ospf | rip | static
The connected parameter indicates that you are redistributing routes to directly attached devices into BGP4.
The ospf parameter indicates that you are redistributing OSPF routes into BGP4.
NOTE
Entering redistribute ospf simply redistributes internal OSPF routes. To redistribute external OSPF routes also, use the
redistribute ospf match external command.
The rip parameter indicates that you are redistributing RIP routes into BGP4.
The isis parameter indicates that you are redistributing IS-IS routes into BGP4.
The static parameter indicates that you are redistributing static routes into BGP4.
Modifying redistribution parameters
FastIron Ethernet Switch Layer 3 Routing
400 53-1003627-04

Brocade Communications Systems FastIron X Series Specifications

General

Brand	Brocade Communications Systems
Model	FastIron X Series
Category	Switch
Language	English