The self-originate option shows self-originated LSAs.
TABLE 65 show ip ospf database link-state output descriptions
This eld Displays
Index ID of the entry
Area ID ID of the OSPF area
Type LS ID Type and ID of the link state advertisement.
Adv Rtr ID of the advertising router.
Seq(Hex) The sequence number of the LSA. The OSPF neighbor that sent the LSA
stamps the LSA with a sequence number. This number enables the device
and other OSPF routers to determine which LSA for a given route is the
most recent.
Age The age of the LSA in seconds.
Cksum The checksum for the LSA packet. The checksum is based on all the elds
in the packet except the age eld. The device uses the checksum to verify
that the packet is not corrupted.
Displaying OSPF ABR and ASBR information
To display OSPF ABR and ASBR information, enter the following command at any CLI level.
device# show ip ospf border-routers 192.168.98.111
router ID router type next hop router outgoing interface Area
192.168.98.111 ABR 193.213.111.111 4/3/1*8/3/1 0
Syntax: show ip ospf border-routers [ ip-addr ]
The ip-addrip-addr parameter displays the ABR and ASBR entries for the
specied IP address.
device# show ip ospf border-routers
router ID router type next hop router outgoing interface Area
1 10.65.12.1 ABR 10.1.49.2 v49 0
1 10.65.12.1 ASBR 10.1.49.2 v49 0
1 10.65.12.1 ABR 10.65.2.251 v201 65
1 10.65.12.1 ASBR 10.65.2.251 v201 65
Syntax: show ip ospf border-routers
TABLE 66 show ip ospf border-routersoutput descriptions
This eld Displays
(Index) Displayed index number of the border router.
Router ID ID of the OSPF router
Router type Type of OSPF router: ABR or ASBR
Next hop router ID of the next hop router
Outgoing interface ID of the interface on the router for the outgoing route.
Area ID of the OSPF area to which the OSPF router belongs
Displaying OSPF trap status
All traps are enabled by default when you enable OSPF.
Displaying OSPF information
FastIron Ethernet Switch Layer 3 Routing
284 53-1003627-04