EasyManuals Logo

Brocade Communications Systems FastIron X Series User Manual

Brocade Communications Systems FastIron X Series
593 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #378 background imageLoading...
Page #378 background image
To change the BGP4 update timer value to 15 seconds, for example, enter the update-time command at the BGP conguration level of
the CLI.
device(config-bgp-router)# update-time 15
Syntax: [no] update-time secs
The secs parameter
species the number of seconds and can be from 0 through 30. The default is 5. The value of 0 permits fast BGP4
convergence for situations such as link-failure or IGP route changes. Setting the value to 0 starts the BGP4 route calculation in sub-
second time. All other values from 1 through 30 are still calculated in seconds.
Enabling fast external fallover
BGP4 devices rely on KEEPALIVE and UPDATE messages from neighbors to signify that the neighbors are alive. For BGP4 neighbors
that are two or more hops away, such messages are the only indication that the BGP4 protocol has concerning the alive state of the
neighbors. As a result, if a neighbor becomes non-operational, the device waits until the Hold Time expires or the TCP connection fails
before concluding that the neighbor is not operational and closing its BGP4 session and TCP connection with the neighbor.
The device waits for the Hold Time to expire before ending the connection to a directly-attached BGP4 neighbor that becomes non-
operational.
For directly-attached neighbors, the device immediately senses loss of a connection to the neighbor from a change of state of the port or
interface that connects the device to the neighbor. For directly-attached EBGP neighbors, the device uses this information to
immediately close the BGP4 session and TCP connection to locally attached neighbors that become non-operational.
NOTE
The fast external failover feature applies only to directly attached EBGP neighbors. The feature does not apply to IBGP
neighbors.
To enable fast external fallover, enter the following command.
device(config-bgp-router)# fast-external-fallover
To disable fast external fallover again, enter the following command.
device(config-bgp-router)# no fast-external-fallover
Syntax: [no] fast-external-fallover
Changing the maximum number of paths for BGP4 Multipath load sharing
Multipath load sharing enables the device to balance trac to a route across multiple equal-cost paths of the same route type (EBGP or
IBGP).
To congure the device to perform BGP4 Multipath load sharing:
• Enable IP load sharing if it is disabled.
• Set the maximum number of BGP4 load sharing paths. The default maximum number is 1, which means no BGP4 load
sharing takes place by default.
NOTE
The maximum number of BGP4 load sharing paths cannot be greater than the maximum number of IP load sharing paths.
Optional BGP4 conguration tasks
FastIron Ethernet Switch Layer 3 Routing
378 53-1003627-04

Table of Contents

Other manuals for Brocade Communications Systems FastIron X Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brocade Communications Systems FastIron X Series and is the answer not in the manual?

Brocade Communications Systems FastIron X Series Specifications

General IconGeneral
BrandBrocade Communications Systems
ModelFastIron X Series
CategorySwitch
LanguageEnglish

Related product manuals