TABLE 19 CLI display of global IP conguration information - Layer 3 switch (continued)
Field Description
Index The policy number. This is the number you assigned the policy when you
congured it.
Action The action the router takes if a packet matches the comparison values in
the policy. The action can be one of the following:
• deny - The router drops packets that match this policy.
• permit - The router forwards packets that match this policy.
Source The source IP address the policy matches.
Destination The destination IP address the policy matches.
Protocol The IP protocol the policy matches. The protocol can be one of the
following:
• ICMP
• IGMP
• IGRP
• OSPF
• TCP
• UDP
Port The Layer 4 TCP or UDP port the policy checks for in packets. The port
can be displayed by its number or, for port types the router recognizes, by
the well-known name. For example, TCP port 80 can be displayed as
HTTP.
NOTE
T his eld applies only if the IP protocol is TCP or
UDP.
Operator The comparison operator for TCP or UDP port names or numbers.
NOTE
This eld applies only if the IP protocol is TCP or
UDP.
Displaying IP interface information
To display IP interface information, enter the following command at any CLI level.
device# show ip interface
Interface IP-Address OK? Method Status Protocol
Ethernet 1/1/1 10.95.6.173 YES NVRAM up up
Ethernet 1/1/2 10.3.3.3 YES manual up up
Loopback 1 10.2.3.4 YES NVRAM down down
Syntax: show ip interface [ ethernet unit / slot / port | loopback num | tunnel num | venum ]
This display shows the following information.
TABLE 20
CLI display of interface IP conguration information
Field Description
Interface The type and the slot and port number of the interface.
IP-Address The IP address of the interface.
Displaying IP conguration information and statistics
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04 127
To Next Page
Loading...
Need help?
General
