To set disable hardware ip checksum check on for example, port range 0-12, enter the following command.
device# disable-hw-ip-checksum-check ethernet 2
disable-ip-header-check set for ports ethe 1 to 12
To set disable hardware ip checksum check on, for example, port range 13-24, enter the following command.
device# disable-hw-ip-checksum-check ethernet 22
disable-ip-header-check set for ports ethe 13 to 24
To clear disable hardware ip checksum check on, for example, port range 13-24, enter the following command.
device# no disable-hw-ip-checksum-check ethernet 13
disable-hw-ip-checksum-check cleared for ports the 13 to 24
NOTE
The port range could be any consecutive range, it may not necessarily be a decimal number.
Syntax: [no] disable-hw-ip-checksum-check ethernet portnum
NOTE
This command only functions on the IPv4 platform.
Disabling IP checksum check
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04 141
To Next Page
Loading...
Need help?
General
