The following Through-Glass button information is reprinted from Through-Glass Button Operation on
page 15.
Through-Glass Button Operation
To actuate a button, press and remove one finger to the glass directly over the marked button area. Remove finger to at least 4
inches away from the glass in between button activations. Through-Glass and mechanical buttons may be held to cycle through
menus or digits in place of repeatedly pushing a button.
Through-Glass Power Save Mode
Through-Glass buttons enter a power saving mode after three minutes of
inactivity. This mode is indicated by a pause symbol (
) appearing in the lower
right of the display. Only the MENU button is monitored in this mode. To activate
the Through-Glass buttons, press and hold the menu button for up to five
seconds. The display will read AWAKE, and the Through-Glass buttons will be
fully enabled.
Through-Glass Disabled Mode
When the cover is removed, the four mechanical buttons located next to the
sensors may be used. The sensors are disabled when a mechanical button is
pressed and will automatically be re-enabled after 60 seconds of inactivity. The
Through-Glass power symbol (
) will blink in the lower right of the display if the
buttons are disabled due to a mechanical pushbutton being pressed.
!
IMPORTANT
Through-Glass buttons will not work if two or more buttons are
detected as being pressed simultaneously. As a result, be careful
to avoid triggering multiple buttons or reaching across one button
location to press another.
To Next Page
Loading...