What to do if Brooks 8200 won't run but the power switch is on?
If the Brooks Air Compressor isn't running, even though the power switch is ON, first check the service fuses, circuit breakers, and wiring related to the power source. Repair any issues you find. Also, inspect the compressor's wiring against its electrical schematic, which can be found in Figure 6-1 on page 6-9.
Why is the cooling water from my Brooks Air Compressor too hot?
If the cooling water exiting your Brooks Air Compressor is hotter than 100°F, first check that the incoming water temperature is between 50°F (10º C) and 90°F (32º C). If the incoming water temperature is correct, the issue may be internal to the compressor.
What to do if Brooks 8200 Air Compressor doesn't run when both switches are ON?
If your Brooks Air Compressor won't start even with both power switches ON, here’s what you should do: 1. Test the thermal protective switch (TS1) on air-cooled compressors, or (TS1) and (TS2) on water-cooled models. If there's continuity, contact the Product Service Department. 2. Ensure the correct phase sequence at the input power cable. 3. Measure and record the current, then contact the Product Service Department.
Why does Brooks Air Compressor pump turn on and off repeatedly?
If the Brooks Air Compressor pump stops and restarts intermittently, check the power source voltage. It should be between 198-250V, 60 Hz or 180-220V, 50 Hz. Restore the correct voltage if necessary.
What to do if Brooks Air Compressor runs but cold head motor won't?
If the compressor in your Brooks Air Compressor is running, but the cold head motor isn't, check the cold head cable for any looseness or defects.
General| Model | 8200 |
|---|---|
| Type | Stationary |
| Power Source | Electric |
| Tank Capacity | 80 Gallons |
| Max Pressure | 175 PSI |
| Pump Type | Two Stage |
To Next Page