Brother DreamWeaver„ VQ3000 User Manual

SEWING THE STITCHES
S-28
■ Basting
a
Select and attach presser foot “J”.
b
Press the “Reverse Stitch” button to sew
reinforcement stitches, then continue
sewing.
c
Sew while keeping the fabric straight.
d
End the basting with reinforcement stitches.
Dart Seam
a
Select and attach presser foot “J”.
b
Sew a reverse stitch at the beginning of the
dart and then sew from the wide end to the
other end without stretching the fabric.
* If automatic reinforcement stitching is preset, a
reinforcement stitch will automatically be sewn at
the beginning of sewing.
a Basting
c
Cut the thread at the end leaving 50 mm
(approx. 1-15/16 inches), and then tie both
ends together.
* Do not sew a reverse stitch at the end.
d
Insert the ends of the thread into the dart
with a hand sewing needle.
Memo
• When you use the basting stitch for
gathering, do not use a reinforcement stitch
at the beginning; you should lift the presser
foot, rotate the handwheel toward you
(counterclockwise), pull up the bobbin
thread and pull a length of top and bobbin
thread out from the rear of the machine.
• You can set the stitch length between 5 mm
(approx. 3/16 inch) and 30 mm (approx.
1-3/16 inches)
a Between 5 mm (approx. 3/16 inch) and 30 mm
(approx. 1-3/16 inches)

Brother DreamWeaver„ VQ3000 Specifications

General

Brand	Brother
Model	DreamWeaver„ VQ3000
Category	Sewing Machine
Language	English