SEWING THE STITCHES
S-32
■ Patchwork (for Crazy Quilt)
Turn back the desired width of fabric and position it
over the lower fabric, then sew so that the stitch
bridges both pieces of fabric.
■ Sewing Curves (Using a Zigzag
Stitch)
Shorten the stitch length setting to obtain a fine
stitch. Sew slowly, keeping the seams parallel with
the fabric edge as you guide the fabric around the
curve.
■ Cord Guide Bobbin Cover (Using a
Zigzag Stitch)
a
Remove the bobbin cover from the machine
(“Setting the Bobbin” of “Basic
operations”).
b
Thread the gimp thread through the hole in
the cord guide bobbin cover from top to
bottom. Position the thread in the notch at
the back of the cord guide bobbin cover.
a Notch
b Gimp thread
c
Snap the cord guide bobbin cover into
place, making sure that the gimp thread can
be fed freely.
* Make sure there are no restrictions when feeding the
thread.
d
Set the zigzag width from 2.0 mm - 2.5 mm
(approx. 1/16 inch - 3/32 inch).
e
Attach presser foot “N”.
f
Position the fabric right side up on top of
the cord and place the cord to the rear of
the machine under the presser foot.
a Fabric (right side)
b Gimp thread
g
Lower the presser foot and start sewing to
make a decorative finish.
To Next Page
Loading...
Need help?
General
