Brother DreamWeaver„ VQ3000 User Manual

SEWING THE STITCHES
Utility Stitches
Sewing S-29
S
2
e
Iron the dart to one side so that it is flat.
Gathering
Use on waists of skirts, sleeves of shirts, etc.
a
Select a straight stitch and attach presser
foot “J”.
b
Set the stitch length to 4.0 mm (approx.
3/16 inch) and the thread tension to
approximately 2.0 (weaker tension).
* If you press after pressing
and then , the stitch length will be set
automatically to 4.0 mm (approx. 3/16 inch) and the
thread tension will be automatically set to 2.0.
c
Pull the bobbin and upper threads out by
50 mm (approx. 1-15/16 inches) (“Pulling
Up the Bobbin Thread” of “Basic
operations”).
a Upper thread
b Bobbin thread
c About 50 mm (approx. 1-15/16 inches)
d
Sew two rows of straight stitches parallel to
the seam line, then trim excess thread
leaving 50 mm (approx. 1-15/16 inches).
a Seam line
b 10 mm to 15 mm (approx. 3/8 inch to 9/16 inch)
c About 50 mm (approx. 1-15/16 inches)
e
Pull the bobbin threads to obtain the
desired amount of gather, then tie the
threads.
f
Smooth the gathers by ironing them.
g
Sew on the seam line and remove the
basting stitch.
Flat Fell Seam
Use for reinforcing seams and finishing edges
neatly.
a
Select and attach presser foot “J”.
b
Sew the finish line, then cut half of the seam
allowance from the side on which the flat
fell seam will lie.
* When the automatic thread cutting and automatic
reinforcement stitching are preset, reinforcement
stitches will be sewn automatically at the beginning
of sewing. Press the “Reverse Stitch” button to sew a

Brother DreamWeaver„ VQ3000 Specifications

General

Brand	Brother
Model	DreamWeaver„ VQ3000
Category	Sewing Machine
Language	English