Brother GT-3 Series - Page 134

6. Replacing Parts
Ass
e
mbling
1. Hold the Bellows (3) with Bellows Guide Plate R (1) and Bellows Guide Plate L (2).
(1)
(3)
(2)
2. Asse
mble Bellows Guide Plate R (1) and Bellows Guide Plate L (2) by the following steps.
Keep those three parts as shown in the step 1 and put the Bellows Guide Plate R (1) through the Bellows
Support Plate (4) and set it to the position, from the back side first then the front side.
GT-3 Series
125
(4)
(1)
Put them through (4)
(1)
Setting Position
Setting Position
(
1
)
(2)
(2)
(3)
The back side The front side