Brother GT-3 Series - Page 146

6. Replacing Parts
Ass
e
mbling
1. Assemble the new Platen Pulse Motor (1) to the Motor Bracket (2) with the four Bolt Sockets (3).
<Note> The aspect of the Harness outlet (4) should be as shown below.
(3)
(2)
(1)
(4)
2.
Asse
mble the Cord Holder 5N (5) with the one Screw (6).
<Note>
- The aspect of the Cord Holder 5N should beat the angle of 45 degrees (see the left photo).
- The covering of the Harness should go to the Motor side by 10 mm (see the right photo).
10 mm
Covering goes to the
Motor by 10 mm.
45°
(6)
(5)
3.
As
semble the Motor Bracket (2) to the Motor Connecting Plate (bottom) with the four Bolt Sockets (7).
(7)
(1)
(2)
GT-3 Series
137