6. Replacing Parts
4.
Pass th
e Harness with clamps and fix it with one Screw, Cord Holder 6N (2), one Screw and one Cord
Holder N5 (3).
<Note> Pull slightly to the right side and pass the Harness so that it will not go loose on the way.
2
3
Do not hang it down.
Do not go loose to the left.
5. Asse
mble the Reduction Belt and adjust the Tension.（See “6-1-5. Adjusting the tension of Platen Belt
and Reduction Belt”.）
6. Fix the Harness (8) with clamps shown below, and connect the Platen Motor Connector to the Main PCB
[CN4].
(8)
Clamp
Connector (CN4)
Clamps
GT-3 Series
138
To Next Page
Loading...
