6. Replacing Parts
B. Removing the Maintenance Unit from GT-3
1. Remove the Cover DB and the Cover PB in the back, and Cover DL and Cover PF in the front. Refer to
“6-1-2. Assembling/Disassembling of the Covers”.
2. Disconnect the connector (2) from the Maintenance PCB (1).
(2)
(1)
3.
Remove the
Connector (2) and the Cord Clamp (3) to make the Harness free.
(2)
(3)
4.
Remove the f
our Bolt Sockets (4) that fix the Maintenance Unit with the printer.
(4)
(4)
GT-3 Series
166
To Next Page
Loading...
