Brother GT-3 Series - Page 176

6. Replacing Parts
5.
Remove the
Flushing Plate (5).
フェルト
スポンジ
(5)
Flushing Sponge
Flushing Felt
0067Ｙ
6. Pull out the Drain Tube from the Waste Ink Tank and prevent the Tube from draining, e.g. use a clip and
some cloth to cover the edge, and pull out the Maintenance Unit from the back.
C. Temporary assembling the Maintenance Unit to the GT-3 body
1.
Insert the Mai
ntenance Unit from the back. Align the two positioning pins with the left/right sides of the
U-shaped grooves (1). It is easier to guide the position by inserting the M4 screws.
(1)
(1)
2.
Tighten the fo
ur Bolt Sockets temporarily to adjust the Maintenance Unit back and forth.
<Note> Pay attention that the Waste Ink Tube (2) should not be bent.
(2)
GT-3 Series
167