Brother GT-3 Series - Page 185

6. Replacing Parts
10.
Remove
the projection on the right side of the Wiper Blade Assy (3) from the Wiper Drive Plate by pulling
the Wiper Drive Plate to the right by 2mm, and pull the Wiper Blade Assy out horizontally.
* Better to prepare a plate with the same width of the Wiper for supporting.
<Note> Do not stretch the Wiper Drive Plate by force, it may be damaged.
Wi
p
er Blade Ass
y
Wiper Drive Plates
In the left side
(3)
11.
Insert the p
rojections (4) of the new Wiper Blade Assy to the oval holes on the left Wiper Drive Plate.
(4)
(5)
(5)
GT-3 Series
176