Brother GT-3 Series - Page 194

6. Replacing Parts
8.
Remove the
Tube Joint (11) and the Maintenance Middle Tube 2 (12) from the Waste Ink Joint (10).
(10)
(11)
(12)
(10)
(12)
9.
Repl
ace to the new Suction Pump Assy (13) and insert the Tube Joint (11) and the Maintenance Middle
Tube 2 (12) to the Waste Ink Joint (10).
Pass the Harness:MNT Motor P(1) through the Bushing (14).
10. Insert the Pump Holder (8) to the Frame (16) and fix it with the left/right Screws (9) with tightening torque
1.5 N·m.
Pass through the Pump Tube (7) at the side of the Frame. Pay attention that the Pump Tube should not
bend around the outlet.
(11)
(10)
(14)
(13)
(12)
(1)
(
8
)
(9)
(8)
(
7
)
(9)
(16)
GT-3 Series
185