Brother GT-3 Series - Page 195

6. Replacing Parts
11.
Insert the Pu
mp Tube (7) to the T Plug (6).
Tighten the Tube Pump (7) with the Band (5) at the root of the T Plug (6).
(5)
(7)
(6)
12. Ins
ert the Sensor (4) to the Harness: MNT Sensor (3).
(4)
(4)
(3)
13.
Con
nect the Connector of the Harness:MNT Motor P (1) from the Maintenance PCB (2).
14. Mount the Maintenance Unit. Refer to “6-1-16. Assembling / Disassembling of the Maintenance Unit”.
(2)
(1)
15. Attac
h the Covers. (Refer to “6-1-2. Assembling/Disassembling of the Covers”.)
GT-3 Series
186