Brother GT-3 Series - Page 244

6. Replacing Parts
10.
Remove the
one Screw (3) and remove the Tube Holder Outside (4).
<Note> Pay attention to the screws not to drop; spread some paper or cloth.
(3)
(4)
11. Shift the Tube from the U
groove (5) in the Tube Holder Inside.
(6
)
(5)
12. Remove the
Tube from the Joint VRFT6 (6).
<Note>
・Rotate the Joint VRFT 6 to the arrow direction in the photo by holding the fitting position of the Tube; Do
not hold the Tube itself, it may be damaged.
・Pay attention to the ink flowing out from the Tube in disconnecting; it may give damage to your hands,
the printer and the table.
(6)
Do not give stress to the upper and
lower Tubes in disconnecting; it may
be damaged.
GT-3 Series
235