Brother GT-3 Series - Page 245

6. Replacing Parts
13.
Insert the
Joint VRSP6 (7) to cover the Tube where you removed the Tube from the Joint VRFT6 (6).
(6)
(7)
14.
Remove
the one Bolt Socket (8) and pull up the Tube Holder Support (10) from the Tube Holder Support
Shaft (9).
<Note> Pay attention not to hook the Tubes in operation.
GT-3 Series
236
15. Remove the two Screws (11).
(6
)
(10)
(8)
(9)
(11)