6. Replacing Parts
21.
Remove the
Tube from the Tube Holder Fix (15).
(15)
22. Loo
sen the Tube Clamp D3 (21) and remove the Tube.
<Note> Pay attention to the ink flowing out from the Tube in disconnecting; it may give damage to your
hands, the printer and the table.
(21)
23. Cover the n
eedle with the protection (cut tube) to protect from the dust and threads.
Tube Joint 2:*VRFP6
Protection (cut tube)
24. Remove the
old Tube from the printer.
<Note> Pay attention not to pull out the other Tubes; do not give damage to the other Tubes in operation.
GT-3 Series
239
To Next Page
Loading...
