Brother GT-3 Series - Page 279

6. Replacing Parts
GT-3 Series
270
Assembling
1. Insert the needle to align the bottom line (A) of the oval hole on the Cartridge Holder and the flange (B) of
the new Needle.
<Note> Be sure to put on the plastic gloves (1) when you hold the Needle tip.
2. Hold the Needle to the Needle Bracket (2) from the back, mount the Washer Plain S 8 (3) and the Nut 8
(4) (refer to the reverse step in Dissembling step 5), and then fix by screwing the Nut 8 (4).
<Note> The tightening torque of the Nut 8 should be 1 N·m.
Reconfirmation
Confirm from the bottom side if the Needle should be fixed on the Needle Bracket with no space left.
3. Remove the Needle-Tip Tube (5) and insert the Filter Cartridge (6).
(1)
(2)
(A)
(B)
(5)
(2)
(3)
(4)
(5)
No space here
(6)