Brother GT-3 Series - Page 329

6. Replacing Parts
5.
Remove the
six screws (7) that fix the Main PCB Assy (5). Remove the one screw (9) for USB Function
Connector (8) at the back of the printer. Disconnect if any cable is connected. Disconnect the LAN Cable
if connected to the Connector (10).
(8)
(9)
(7)
(10)
6.
Mak
e the Main PCB Assy (5) slide to the left until the LAN Connector (10) is out of the Control Box.
Rotate the right side of the Main PCB Assy to your side with your left hand and remove it from the Control
Box.
(5)
(5)
(10)
(10)
GT-3 Series
320