Brother GT-3 Series - Page 354

6. Replacing Parts
GT-3 Series
345
（
(
Note for 6 and 7
)
Insert the Head FFC Su
pp
ort to the mesh of the FFC Sleeve.
1. Mount the Exhau
st fan with four Screws and connect the Connecter if it is removed for smooth operation.
2. Follow the reverse steps in reassembling.
8. Connect the FFC to the
CN6 and CN8 on the
Carriage PCB.
5. Pass the FFC at the backside
of the Encoder Cover.
10. Adjust the
length of the FFC
at the curve here.
4. Fold the FFC at the FFC Clamp.
7. How to fold the FFC at
the FFC clamps
6. How to fold the FFC with clam
p
s
9. Fold the claws naturall
y
.
Clam
p
s
FFC
Plastic cover
Metal plate
(Note for 6)
Make the “dent” side of the Head FFC
Support mount as the inside