Brother GT-3 Series - Page 357

7. Transporting the GT-3 Series / Required Maintenance for Long-term Storage
1.
Turn O
N the printer and move the Platen to the inside of the printer with Platen Button.
2. Select [ Maintenance ] > [ Head Replacement ] of the menu, select any Print Head and press the OK
Button.
<Note>
This operation is to move the Caps down and the Carriage to the side.
3. The Carriage moves to the right, above the Flushing Plate. Follow the message on the Display and turn
OFF the printer.
4. After you turn OFF the printer, remove the Print Heads safe by referring to “6-1-38. Print Heads”.
5. Connect the Tube Joint 1 (2) and 2 (3) to the Tube (1).
(1)
(2)
(3)
6. Con
nect the Cap Tube (4) and Tube Joint 1 (2) and 2 (3) to the Print Heads.
(2)
(3)
(4)
7. Clea
n
the Nozzle Cover Sheet (5) with Wash Liquid or Maintenance Solution and apply it on the surface
of the Nozzles.
(5)
GT-3 Series
348