Brother HL-5270DN

Control panel setup
8 - 3
8
(HL-5280DW)
See (HL-5270DN) on page 8-2 for the HL-5270DN NETWORK menu table.
Note
In order to make your wireless settings effective, you must select the APPLY option from the WIRELESS sub
menu and then select YES or YES&REPORT. If you do not do this, the network settings will not be used unless
you switch the printer off and then on again. If you select YES&REPORT, the printer will print the network
printer server settings list.
Level one Level two Level three Level four Options 1 Factory settings
NETWORK WIRED WIRED
ENABLE
- =ON, OFF =ON
TCP/IP TCP/IP ENABLE =ON, OFF =ON
IP ADDRESS= [000-255].[000-255].
[000-255].[000-255]
[169].[254].[001-254].[000-255]
1
SUBNET MASK= [000-255].[000-255].
[000-255].[000-255]
255.255.0.0
2
GATEWAY= [000-255].[000-255].
[000-255].[000-255]
0.0.0.0
IP BOOT TRIES =0 to 32767 =3
IP METHOD =AUTO, STATIC, RARP,
BOOTP, DHCP
=AUTO
APIPA =ON, OFF =ON
IPV6 =ON, OFF =OFF
ENET - =AUTO, 10B-HD, 10B-FD,
100B-HD, 100B-FD
=AUTO
NETBIOS/IP - =ON, OFF =ON
SET
DEFAULT
OK? - -
WLAN WLAN
ENABLE
- =ON, OFF =ON
TCP/IP TCP/IP ENABLE =ON, OFF =ON
IP ADDRESS= [000-255].[000-255].
[000-255].[000-255]
[169].[254].[001-254].[000-255]
1
SUBNET MASK= [000-255].[000-255].
[000-255].[000-255]
255.255.0.0
2
GATEWAY= [000-255].[000-255].
[000-255].[000-255]
0.0.0.0
IP BOOT TRIES =0 to 32767 =3
IP METHOD =AUTO, STATIC, RARP,
BOOTP, DHCP
=AUTO
APIPA =ON, OFF =ON
IPV6 =ON, OFF =OFF