6 - 8 REMOTE FAX OPTIONS (MONOCHROME ONLY)
95
Change the Fax Forwarding
or Fax Storage settings
1 OFF You can select Off after you have retrieved
or erased all your messages.
2 Fax Forwarding If you hear one long beep, the change has
been accepted. If you hear three short beeps,
you cannot change it because the conditions
have not been met (for example, registering a
Fax Forwarding number). You can register
your Fax Forwarding number by entering 4.
(See Changing your Fax Forwarding number
on page 6-9.) Once you have registered the
number, Fax Forwarding will work.
4 Fax Forwarding number
6 Fax Storage
96 Retrieve a fax
2 Retrieve all faxes Enter the number of a remote fax machine to
receive stored fax message(s). (See page
6-9.)
3 Erase faxes from the
memory
If you hear one long beep, fax messages
have been erased from the memory.
97 Check the receiving status You can check whether your machine has
received any fax or voice messages. If yes,
you will hear one long beep. If no, you will
hear three short beeps.
1 Document
2 Voice
98 Change the Receive Mode If you hear one long beep, your change has
been accepted.
1 TAD
2 Fax/Tel
3 Fax Only
90 Exit Pressing 9 0 will allow you to exit Remote
Retrieval. Wait for the long beep, then replace
the handset.
Remote commands Operation details
To Next Page
Loading...
Need help?
General
