Chapter 2
2 - 3
General Setup
Setting the Mode Timer
The machine has three temporary mode keys
on the control panel: Fax, Scan and Copy.
You can change the number of seconds or
minutes the machine takes after the last Scan
or Copy operation before it returns to Fax
mode. If you select
Off, the machine stays in
the mode you used last.
1
Press Menu/Set, 1, 1.
2
Press ▲ or ▼ to select 0 Sec,
30 Secs, 1 Min, 2 Mins, 5 Mins or
Off.
Press Menu/Set.
3
Press Stop/Exit.
Setting the Paper Type
To get the best print quality, set the machine
for the type of paper you are using.
1
Press Menu/Set, 1, 2.
2
Press ▲ or ▼ to select Plain, Thin,
Thick, Thicker or Transparency.
Press Menu/Set.
3
Press Stop/Exit.
Note
■ The machine ejects paper with printed
surfaces face down onto the output paper
tray in the front of the machine. When you
use transparencies or labels, remove
each sheet immediately to prevent
smudging or paper jams.
■ You can select Transparency in Step 2
if
Letter, Legal or A4 paper size has
been selected (Menu/Set, 1, 3).
General Setup
1.Mode Timer
General Setup
2.Paper Type
To Next Page
Loading...
