Brother MFC-8370DN

Making copies
83
12
h Put the next page on the scanner glass.
Press OK.
Repeat steps g and h for each page of
the layout.
i After all the pages have been scanned,
press 2 in step g to finish.
Place the document face down in the
direction shown below:
12
 2 in 1 (P)
 2 in 1 (L)
 4 in 1 (P)
 4 in 1 (L)
Tray selection 12
You can change the Tray Use only for the
next copy.
a Make sure you are in Copy mode .
b Load your document.
c Use the dial pad to enter the number of
copies (up to 99).
d Press Options.
Press a or b to choose Tray Select.
Press OK.
e Press a or b to choose the MP>T1>T2,
T1>T2>MP, #1(XXX), #2(XXX) or
MP(XXX).
Press OK.
f Press Start.
Note
• T2 or #2 appears only if the optional paper
tray is installed.
• T2 or #2 is available for MFC-8380DN.
• To change the default setting for Tray
Select, see Tray Use in copy mode
on page 23.
Downloaded from ManualsPrinter.com Manuals