Wireless configuration for Macintosh
®
63
5
10
To communicate with the un-configured wireless
machine, change the wireless settings on your
Macintosh
®
to the machine’s default settings which
are shown on the screen. Click Next.
11
If more than one wireless machine is available on
the network, the following list appears. If the list is
blank, check if the machine is powered on, and then
click Refresh. Choose the machine you wish to
configure, and click Next.
Note
The Default Node name of the NC-xxxx (where “xxxx” is your model name) is “BRW_xxxxxx” (where “xxxxxx”
is the last six digits of Ethernet address).
Item Record the current wireless computer settings
Communication mode:
(Infrastructure/Ad-hoc)
Channel: (1-14)
Network name
(SSID/ESSID)
Authentication method
(Open system/Shared key)
Encryption:
(None/WEP/WPA/WPA2-PSK/
LEAP)
Encryption key:
To Next Page
Loading...
