Brother MFC-9180 - Page 49

ADVANCED FAX USE
Advanced Sending 41
Changing the Memory Security Password
1 Press Menu/Set, 2, 0, 1.
2 Press or to choose SET PASSWORD.
3 Press Menu/Set.
The screen prompts you to enter the old password.
4 Enter the current password.
5 Press Menu/Set.
6 Enter a 4-digit number as a new password.
7 Press Menu/Set.
The screen prompts you to re-enter the new password.
8 Enter the new password again and press Menu/Set.
9 Press Stop/Exit.
Switching Memory Security ON
1 Press Menu/Set, 2, 0, 1.
2 Press or to choose SET SECURITY.
3 Press Menu/Set.
The screen prompts you to enter the password.
4 Enter a 4-digit password, followed by Menu/Set.
This is the same as the security password of the machine already stored.
The screen displays ACCEPTED for 2 seconds, followed by SECURE MODE - Memory Security
is now switched ON.
If the password you enter at Step 4 is incorrect, the screen would display WRONG
PASSWORD. After 2 seconds the display will then return to normal (displaying the
date & time). You must then start from Step 1 to set Memory Security.
OLD PASSWD:XXXX
ENTER & SET KEY
NEW PASSWD:XXXX
ENTER & SET KEY
VERIFY:XXXX
ENTER & SET KEY
PASSWORD:XXXX
ENTER & SET KEY