Network Scanning (For models with built-in network support)
195
13
Scan to Image 13
When you choose Scan to Image, your document will be scanned and sent directly to the computer you
designated on your network. The ControlCenter software will launch the default graphics application on the
designated computer.
a Load your document.
b Press (SCAN).
c Press a or b to choose Scan to Image.
Press OK.
d Press a or b to choose the destination computer you want to send to.
Press OK.
If the LCD prompts you to enter a PIN number, enter the 4-digit PIN number for the destination computer
on the control panel.
Press OK.
For DCP models, press a, b, d or c to select the first digit of the PIN number. Press OK to move the cursor,
then use a, b, d or c to select the second digit. Repeat until you have entered all four digits of the PIN
number.
e Press Black Start or Color Start.
The machine starts the scanning process.
• Scan type depends on the settings of the Device Button tab, Black Start or Color Start do not change
the settings.
• If you want to change between color and black and white scanning, choose color or black and white in the
scan type option on the Device Button tab of the ControlCenter configuration screen. (For Windows
®
, see
SCAN on page 58. For Macintosh, see SCAN on page 156.)
To Next Page
Loading...
Need help?
General
