35
Entering a Serialise Label
EDITING A LABEL
Press the OK or Enter key to display the screen that you set.
Example:
• When you press the Shift and Serialize keys, you can change the settings. After changing
the settings, the message “OK to Overwrite the Data after This Position?” appears. If you
want to overwrite the settings, press the OK key.
• You can select “All”, “Current”, or “Range” when printing if there are multiple pages of
labels.
• To print labels refer to “Printing a Label” on page 38.
•Press the Esc key to return to the previous step.
• Serialise mode can be also applied to barcodes. A barcode is counted as a character.
• Any symbols or other non-alphanumeric characters in the auto-numbering sequence are ignored.
• Serialise mode sequence can only contain a maximum of five characters.
• The “Count” value can be set to a maximum sequence number of 99.
• The “Incremented by” value can be set in increments of one to nine.
Letters and numbers increase as shown below:
0
1 ...9
0
...
A
B ...Z
A
...
a
b ...z
a
...
A0
A1 ...A9
B0
...
Spaces (shown as underscores “_” in the example below) can be used to adjust the spacing
between characters or to control the number of digits that are printed.
_9
10 ...99
00
...
_Z
AA ...ZZ
AA
...
1_9
2_0 ...9_9
0_0
...
To Next Page
Loading...
