81
Error Messages
TROUBLESHOOTING
Select Other Cut
Option!
The tape length set using the tape length setting is shorter than the
total length of the left and right margins applied for the “Large Margin”
cutting option. You must select a different cutting option.
Close Cover! The Rear Cover is open. Close the cover when printing.
Installed tape is
not compatible
with this machine!
Use a compatible tape.
Line Limit! Max
297 Lines per
Label
You can enter up to 297 lines in the whole page and blocks.
Block Function is
not Allowed!
In this setting, you cannot add or delete blocks.
Line Limit ! Max 2
Lines
When using Self-Laminating Tape, you can print up to two lines.
Line Limit! Max 3
Lines
The PUNCH-DOWN BLOCK layout allows to print up to 3 lines/block.
This Function
Requires 9mm or
Wider Tape!
The PUNCH-DOWN BLOCK layout must use 9 mm or wider tape
cassettes.
Sequence Type
Must be None
When Editing!
Text cannot be edited when you set Sequence Type in PUNCH-
DOWN BLOCK to Horizontal or Backbone.
No Database
Found!
The Database key on the printer was pressed while there is no
database file saved in the printer.
No Data! You tried to open a database file which doesn’t contain any data.
Bar Code Error! Barcode labels were attempted to print from a database.
The printer will display this message when the selected range of the
database includes invalid characters/numbers not supported by the
barcode protocol.
Memory Full!
Reduce File Size
to Proceed
The total data size exceeds the built-in flash memory after editing
database records.
Hi-Res Print Not
Supported with
This Media!
Cannot print labels in high resolution mode when non-supported
media (fabric tape, heat shrink tube etc.) is installed in the printer.
Message Cause/Remedy
To Next Page
Loading...
