BRUEL & KJAER 2032 - The Measurement Setup

3.4. THE MEASUREMENT SETUP
18
The MEASUREMENT SETUP defines the measurement which is taking place. It can be
displayed on the lower half of the 2032 Display, see Fig.3.3.
The MEASUREMENT
SETUP
Fig.3.3. The MEASUREMENT SETUP
Usually, the MEASUREMENT SETUP is selected prior to a measurement. It can, howev-
er, be changed while a measurement is in progress. The MEASUREMENT SETUP pa-
rameters are:
Setup
Label Measurement
Measurement
Channel
Mode
Trigger Mode
Slope
Level
Delay
After Trigger
Between Channels
Averaging Type
Number
Overlap
Accept
Frequency Span
Centre Frequency
Zoom/Baseband
Centre Frequency
External Sampling
Weighting Different or Common
Ch. A I Ch. B Function
Ch. A I Ch. B Shift
Ch. A I Ch. B Length
Ch. A I Ch. B Max. Voltage
Polarity
Input
Filter
Calibration
Unit
Generator
Signal