BRUEL & KJAER 2032 - Index to the MEASUREMENT SETUP Control Fields; Index to the DISPLAY SETUP Control Fields; Index to the CURSOR SETUP Control Fields; Index to Other Control Fields

In the case of alphanumeric fields, the field settings are represented by numeric codes.
The codes can then be entered via the numeric keyboard
to go directly to the required
setting, avoiding the need
to index through intervening settings. The numeric codes are
given in the
description of the fields, and are summarised in Section 5.6. For instance,
with reference
to the Measurement Mode control fields, Section 5.2.1, entering a 2 into
the first field and a 0 into the second would set the 2032 to Dual Channel Spectrum
Averaging.
In the following description the respective codes precede the allowed al-
phanumeric control field settings. Note, however, that they do not appear on the 2032
Display.
As in Chapter 4, an index to the Chapter in alphabetical order is given, in order to
assist the user in finding the relevant section should clarification of a control field be
required. Any
control field should be looked up. first under the main heading MEA-
SUREMENT SETUP, DISP~AY SETUP, CURSOR SETUP, and other control fields and
then under the
control field name. Fig.5.1 shows the division of the 2032 Display into
the MEASUREMENT SETUP,
DISPLAY SETUP, and CURSOR SETUP groups of control
fields.
5.1.1. Index to the MEASUREMENT SETUP Control Fields
Averaging .......................................................... 57
Input for Ch. A and 8 .................................... 61
Centre Frequency ............................................ 59
Measurement .................................................... 54
Delay .................................................................. 56
Trigger ............................................................... 55
Frequency Span ............................................... 58
Weighting .......................................................... 60
Generator . . . . . ... .... . . . ................... ................. ....... 62
5.1.2. Index to the DISPLAY SETUP Control Fields
A-weighting ....................................................... 66 - Coherence ...................................... 70
8owtie Correction ........................................... 78 - Correlation Functions ................... 71
Differentiation .................................................. 77 - Enh. Time A vs. 8 ........................ 70
Function ............................................................. 64 - Freq. Response Functions .......... 71
Function Coordinates ..................................... 65 - Impulse Response ........................ ~ 71
Integration ......................................................... 77 - Nichols Plot .................................... 7 4
X-Scaling - Frequency Domain ................. 76
- Nyquist Plot .................................... 73
- Time Domain .............................................. 75 - Probability Density ........................ 70
- Exceptions - Enh. Time A vs. 8 .......... 76 - Probability Distribution ................ 70
- Nichols plot .................................... 76 - Phase ............................................... 73
- Nyquist plot .................................... 76
- Signal to Noise Ratio ................... 70
- Probability Density ........................ 76 - Sound Intensity .............................. 72
- Probability Distribution ................ 76
-Time A vs. 8 .................................. 70
- Time A vs. 8 .................................. 76
Y-scaling - Frequency Domain .................. 69
- Time Domain .............................................. 67
- Exceptions - Cepstrum ......................... 71
5.1.3. Index to the CURSOR SETUP Control Fields
Auxiliary Information Field ............................ 86 Main Cursor ..................................................... 81
Cursor Control Field ...... .. .. .. ............ ............... 80 Mask Cursor .................................................. .... 85
Delta Cursor .......................... ........... ................ 84 Reference Cursor ...... .. .. .................... .............. 86
Harmonic Cursor ............................................. 82 Sideband Cursor ............ ................ .... ............. 83
5.1.4. Index to other Control Fields
Data Source ..................................................... 89
Number of Averages ...................................... · 90
Longpass ........................................................... 92
Shortpass ........................ ................. ................. 92
Measurement Setup Reference .... .. .. .. .......... 91 Universal Parameter Selector ....................... 93
53