BRUEL & KJAER 2032 - The Reference Cursor; The Auxiliary Information Field

5.4.7. The Reference Cursor
Reference Cursor
Fig.5.27. The Reference Cursor Control Fields
The Reference Cursor is used to make measurements referenced to the current value
of a single point on a trace. The reference is selected using the X field and the DIS-
PLAY "Set Special Cursors" pushkey, see Section 4.2.3.
REF Y: XXX
x:D
~X: XXX
5.4.8. The Auxiliary Information Field
Auxiliary Information
Fig.5.28. The Auxiliary Information Control Field
86