BRUEL & KJAER 2032 - Controls Used in the Display of Data

MEASUREMENT SETUP 11 is copied into MEASUREMENT SETUPS
Dn, Sn, Wn, 1, 2, ..... , 10.
DISPLAY SETUP 11 is copied into DISPLAY SETUPS Wn, Wn, 1, 2,
..... , 10.
The Display Format is set to single trace with the MEASUREMENT
SETUP,
W11·
DISPLAY SETUP W
11
is selected for both the upper and lower traces.
The Reference
Measurement Setup field is set to W
11
.
The MEASUREMENT
SETUP label field is set to W
11
.
The
Cursor is reset.
The
IEC Interface Terminator is set to 3, (= EXT).
The IEC Interface Service Request mask Serial Poll is disabled.
In
addition to the four levels of SYSTEM RESET described above, a further two special
SYSTEM RESETS are available:
SYSTEM RESET CURSOR:
Obtained by:
1. Pressing SYSTEM RESET and then the CURSOR pushkey.
2. Releasing SYSTEM RESET.
3. Releasing CURSOR.
SYSTEM RESET CURSOR performs a SYSTEM RESET and resets the
Cursor fields to the Main Cursor with the Cursor placed in Element
Number 0. The Flexible Cursor field is set to read the same as the
Main
Cursor, should the Main Cursor be moved from Element Number
0.
SYSTEM RESET SELF-TEST: See Chapter 11 for details.
4.2.3. Controls used in the Display of Data
r-- - ----· _ :~~:.: -------1
~ ........... ~
,.--- -- - -- /'oeki S•tec! -- --------
1
r--- ------f .. •tl (>'!tfy· ·- - --- - --,
s•--
i
I
-
II II
; ;
I
I
II
l'J
,-~~-----:E.:·-----~,
m
•
if
II II
'I
· - ~- ... .. "¥
I
.::.
i
;;
i ll l• i
I I
r;
I
I
I e
r-~- •-• - ~ - - ;
•
a
··-
- -h .
r- -- ~ .. ... .. '-.o~ --,
i
l ll l t• l
I I II I
I I
I
El i
t :a t• :
II lli
Cl
\11
if E! lil
!!
Fig.4.6. Controls used for the Display of Data on the 2032
DISPLAY:
.------ Display-------.,
Auto Measurement
Scale Format Setup
Ill
32
"Auto Scale" - causes the Display to be autoscaled such that the
largest numeric value of the function or part of function displayed
becomes the new Y full-scale.
The DISPLAY SETUP n becomes the WORKING DISPLAY SETUP Wn.
If a dual-trace format is in use, the autoscale is performed on that
trace which has the Field Selector placed in its DISPLAY or CURSOR
SETUP.
To
autoscale both traces:
1. Press "Auto Scale".